Your attic access is an often overlooked part of the insulation in your ceiling.
Your ceiling needs to have a continual thermal boundary so that no part is left uninsulated.
Our custom made attic hatch cover will continue the thermal boundry so that a considerable amount of energy is not lost thru this uninsulated area. This will help to decrease air infiltration thru cracks in your floor by lowering the stack effect that is present in every home.
Average overall R-8 Insulation Value
Standard Model for all size attic hatch
Custom made cover for your pull down ladder leading into your attic. This item will insulate the place where your pulled down ladder leading to your attic is located. Most of the attic pull downs are not insulated and this is a huge energy waste for your home. Air will also infiltrate and ex-filtrate in your home because there is no seal located around the trim. This will also help to limit the air pulled from your crawlspace to inside of your home because of the stack effect from the bottom of your home to the top.
______________________________________________
- The cover is sealed at all seams with insulative tape and with foam board caulk.
- Custom handles allow you to handle and move the cover with ease.
- Weights less than 7 pounds.
- Weatherstripping on side facing down onto the frame of the ladder pulldown for a snug air-tight fit.
- Insulation values are R-7 to R-9 for the standard model
- Insulation values are R-11 to R-13 for the heavy duty version
- Additional thermal radiant reflective barrier for additional insulation values of approximately R-15 for heat transfer.
Same as the above but with additional insulative value.
Special Heavy Duty Version
Average overall R-12 insulation value
- Has 1/3 more insulation than the standard model
- Only weights 1 additional pound
- Will help to reduce your utility bill
- Helps save the environment
